Is your car window not moving up or down? The window regulator cable might be the problem. This guide will help you fix it. Follow these steps to rewind the cable. It is easy and anyone can do it.
What You Need
Before you start, gather these tools:
- Flathead screwdriver
- Phillips screwdriver
- Socket wrench
- Grease
- Replacement cable (if needed)
Credit: www.youtube.com
Step 1: Remove the Door Panel
First, you need to remove the door panel. This will give you access to the window regulator. Follow these steps:
- Use the flathead screwdriver to remove the screws from the door panel.
- Gently pull the panel away from the door.
- Disconnect any wires connected to the panel.
Be careful not to break the panel. Set it aside safely.
Step 2: Locate the Window Regulator
The window regulator is inside the door. It is a metal track with a cable. The cable moves the window up and down. Look for it behind the plastic cover.
Step 3: Remove the Window Regulator
Now, you need to take out the window regulator. Here is how:
- Use the socket wrench to remove the bolts holding the regulator.
- Carefully pull the regulator out of the door.
- Take note of how the cable is wound around the regulator.
This will help you when you rewind the cable.
Step 4: Inspect the Cable
Check the cable for any damage. If it is frayed or broken, you need a new one. If the cable is fine, you can reuse it.
Step 5: Rewind the Cable
This is the most important step. Follow these instructions carefully:
- Start by attaching one end of the cable to the drum.
- Wind the cable around the drum in the same way as before.
- Make sure the cable is tight and secure.
- Attach the other end of the cable to the regulator.
Use grease to lubricate the cable. This will help it move smoothly.
Step 6: Reinstall the Window Regulator
Put the window regulator back into the door. Follow these steps:
- Place the regulator back in its original position.
- Secure it with the bolts you removed earlier.
- Make sure the cable is still tight and secure.
Credit: www.howacarworks.com
Step 7: Test the Window
Before you put the door panel back, test the window. Connect the wires to the window switch. Press the switch to see if the window moves up and down.
If the window works, you have done a good job. If it does not, check the cable again.
Step 8: Reattach the Door Panel
Once you are sure the window works, put the door panel back. Follow these steps:
- Reconnect any wires you disconnected earlier.
- Align the panel with the door.
- Screw the panel back into place.
Conclusion
Rewinding a window regulator cable is not hard. With this guide, you can fix your car window in no time. Remember to be careful and take your time. Good luck!